Site Search
About Hochiki

Letter(Compatible Panels for Hochiki Australia's AS approved Analogue Sensors) Version 2

21st July 2017

29June 2017

To Whom It May Concern

Re: Compatible Panels for Hochiki Australia’s AS approved Analogue Sensors

Hochiki Australia has recently received inquiries from customers about whether any testing for compatibility of Hochiki Australia’s AS approved Sensors with Fusion Advanced's panels has been conducted, and whether those products are compatible.

Hochiki Australia has not commissioned any independent third party testing of the compatibility of Hochiki Australia’s AS approved Sensors with Fusion Advanced's panels. 

Any such testing that may have been undertaken has occurred without Hochiki Australia's consent and without Hochiki Australia's input into testing scope, criteria, and parameters. Hochiki Australia is therefore not in a position to comment on the robustness or reliability of any such testing.

Hochiki Australia is aware of the existence of a report by BSI ("Test Report 8546367 Issue 2") issued to Advanced Electronics Ltd.  That BSI Test Report does not report on the compatibility of Hochiki Australia's AS approved Sensors with Fusion Advanced's panels, nor refer to Hochiki Australia's AS approved Sensors.

Hochiki Australia’s AS approved Sensors are compatible with the following fire control panels, which have been tested and approved for use with Hochiki Australia's AS approved Sensors.

•              Manufacturer Kidde Australia Pty Ltd/Model: NFP1&2, Phoenix, FIRENET

•              Manufacturer Kentec Electronics Ltd /Model: Syncro AS, Taktis

Hochiki Australia’s AS approved Sensors are supplied on the basis that they be used only with compatible fire control panels.  Without limiting any rights that consumers may have under the Australian Consumer Law, Hochiki Australia does not warrant the proper operation of any Hochiki Australia’s AS approved sensor that has been connected to a fire control panel which is not compatible with Hochiki Australia’s AS approved Sensors, and will not be responsible for any loss or damage caused by the connection or use of its sensors with panels that are not compatible.

Please contact us for further information on Hochiki Australia's AS approved Analogue Sensors and compatibility with fire control panels.

Letter(Compatible Panels for Hochiki Australia's AS approved Analogue sensors) version 2